ALMiG Controls

ALMiG Air Control II

air-control-2-controls-almig

The ALMIG AIR CONTROL 2 is a basic but intelligent microprocessor controller that ALMiG manufactures specifically for the FLEX 6-30 series of screw compressors. This series of control can not be used for any other type of compressor or other brands. With permanent display of idle times, internal pressure, compressor temperature, and actual network pressure the ALMiG AIR CONTROL 2 gives you complete information about your FLEX 6-30 series screw compressor.

Features

  • Integrated microprocessor controller
  • Back lit, dot matrix LCD display
  • System optimizer for lowest power consumption
  • Pressure optimizer for constant network pressure (+/- 2 psi)
  • VSD soft start feature to avoid power peaks during startup
  • RPM percentage monitor
  • Pre alarm system for scheduling the preventive maintenance
  • Automatic shut-down before damage
  • Monitor for temperature, main motor, fan motor, drive and system pressure
  • Service hour counter for air filter, oil, oil filter and fine separator
  • Automatic restart after power loss
  • Remote start/stop features

Hardware

  • Advanced, high performance microcontroller design
  • Programmable, five button keypad
  • Instantaneous monitoring of all parameters and their set points, actual status, pressure, temperature, faults or warnings
  • High speed digital signal processor
  • Digital inputs to monitor external accessories like dryers or filters
  • Digital outputs to control external accessories like dryers, fans, and heating device
  • Automatic backup before shutdown