ALMiG Controls

ALMiG Air Control III

air-control-3-controls-almig

The ALMiG AIR CONTROL III is the most advanced controller series ALMiG manufactures for all compressors above 50 HP and for the VARIABLE series as a standard feature. This controller is also able to be installed on any other brand of compressor in today's market. The ALMiG AIR CONTROL III is truly unique in that it is manufactured with an integrated sequencer for controlling up to 8 compressors. This controller is also setup for connection to a factory wide data bus. The technology needed to operate and monitor up to 8 compressors simultaneously is advanced and allows for another unique feature: operating diagrams.

These diagrams can display the following:

Utilization of the compressor
Total operating hours
Full load hours
Idle times
Shutdown times
VSD percentage
Pressure diagram
Temperature diagram
Produced CFM of air
Daily profile
Weekly profile
Service intervals / hours

With this advanced technology as well as permanent display of idle times, internal pressure, actual network pressure, and compressor temperature you have all the control necessary to maintain and operate an advanced, multi-compressor system.

Features

Integrated microprocessor controller
2.5 inch X 4.5 inch, 240 X 128 pixel, plaintext LCD display
System optimizer for lowest power consumption
Pressure optimizer for constant pressure (+/- 2 psi)
VSD soft start feature to avoid power peaks during startup
RPM percentage monitor
Pre alarm system for scheduling preventative maintenance
Automatic shut-down before damage
Monitor for temperature, main motor, fan motor, drive and system pressure
Service hour counter for air filter, oil, oil filter and fine separator
Automatic restart after power loss
Remote start/stop features
Self-test before every start-up
7 input / output timers for digital switching (on / off)
7 timers pressure reduction

Hardware

Advanced high performance microcontroller design
Programmable, five button keypad
Direct access to the VSD parameters
Instantaneous monitoring of all parameters and their set points, actual status, pressure, temperature, faults or warnings
High speed digital signal processor
Digital inputs to monitor external accessories like dryers or filters
Digital outputs to control external accessories like dryers, fans, and heating devices
Remote start/stop interface
Automatic backup before shutdown